Self Lubricating Polyacetal Bushing,POM, china supply, charged or free samples

Maintenance-free, self lubricating bearing polyacetal Coted Strips

The structure of this prelubricated yellow bushing strip material consists of spherical powdered bronze sintered onto a steel backing and polyacetal resin impregnated into the surface.

Metal-polymer-composite material Polyacetal-Copolymer bearing material (POM)

Cylindrical bushes Flanged bushes Thrust washers Flanged washers Strips

TOP BEARINGS POM Coted bushing based sliding bearing also similar Dx bushing, boundary lubrication bearing,SF-2 oilless bearing,dry bearing, POM lined plain dry bush. It has similar material structure with DU bushing. The difference is the layer with POM coated. We are leading exporter of POM Coated Bushing,sliding bearing,boundary lubrication bearing,Dry Bearing in china.

Dry bearing material Metal-polymer-composite material POM with lubrication indents

TOP-20 Strips, Slide paths PAS self lubricating low-maintenance

Wrapped POM Lined Bearings Steel + Bronze Powder + POM(DX) Strips

Our POM range of wrapped acetal lined bearings are suitable for rotary and oscillating movement applications.

The TOP plain bearings are available in metric and imeprial sizes as standard.

Our in-house machining service is able to offer non-standard sizes to suit customer specific requirements.

Strips are available in two material groups:

• Material group P1 for maintenance-free, dry-running applications

• Material group P2 for low-maintenance, lubricated applications

For the advantages of each group and help deciding which material group is best for the relevant use, please refer to the information provided in the section cylindrical bushes, flange liners and thrust washers.

TOP-20 Flange liners PAF

• Marginally lubricated bushings for grease or oil lubricated applications

• Standard parts contain grease indents in the sliding layer; plain sliding layer available by request

• Optimum performance under relatively high loads and low speeds

• Suitable for linear, oscillating and rotating movements

• Wide range of parts available from stock

Suitable for rotating and oscillating movement, less maintenance requirements due to the long re-lubrication intervals, lower wear, lower susceptibility to edge loading, no absorption of water and therefore no swelling, good damping behaviours, good resistance to shock loads.

1. POM thickness 0.30~0.50 mm. It provides high wearresistance and low friction even with only minute volume oflubricant are supplied, this bearing surface carries a pattern of circular indents which should be filled with grease on assembly of the bearing.
2. Sintered bronze powder thickness 0.20-0.35mm. A special composition of powdered copper is thermally fused to the steel backing. This contact layer acts as an anchor for the PTFE layer and conducts the thermal build up away from the bearing surfaces.
3. Low-carbon steel.Setting the foundation of the bushings, the steel back provides exceptional stability,load carrying and heat dissipation characteristics.

• Metal-Polymer Composite Bushing Material

• Steel Back + Porous Bronze Sinter + POM with Lubrication Indents

•  

Sliding layer POM with or without lubricant indents for machining Porous Bronze Sinter Steel Back

Bearing forms available in standard dimensions
· Cylindrical bushes
· Thrust washers
· Sliding plates

Metric bearings and imperial bushings made to order: standard bushing forms in special dimensions, half-bushings, special shapes obtained by stamping, bearings with locating notches, lubricant holes and machined grooves, customized bushing designs

• Rear chassis hinges

• Articulation joints

• Spindles of drills

• Gearboxes & clutches

• Grinding and milling machines